Latest activity
-
-
Torch Red C5 Corvette Coupe (targa), 58, 900 miles, originally supplied to Japan with factory-fitted Euro spec options like headlights...
-
-
Maybe a car nutter natter then ??? 🤣 -
teamzr1 replied to the thread Recurrent misfiring problem.Have you re-torqued bank 1 head and manifold for bank 1 ? Could you be using the wrong sparkplug heat range and gap ? leak of gasket for... -
Roscobbc replied to the thread Recurrent misfiring problem.That 'issue' I went in to detail about was using Hedman headers and affected no. 4 plug boot. It re-occurred much later when upgrading... -
antijam replied to the thread Recurrent misfiring problem.I've checked the distributor cap very carefully - and swapped it out for another - and checked that it's seating properly. Given that my... -
Chuffer replied to the thread What have you done today.Maybe a car nutter natter then ??? 🤣 -
Good points Jon - whilst the MSD system puts out more than enough spark for most applications - I've found that the MSD rotor arm can... -
I had exactly the same issue with my 427 engine. This took me about 9 months to find. It was not long after I'd installed an MSD...
-
Good points Jon - whilst the MSD system puts out more than enough spark for most applications - I've found that the MSD rotor arm can...
-
Mad4slalom replied to the thread What have you done today.Err who proof reads your posts chuffs ,? I am sure that should have read “car Nutter meet” !!🤣🤣👍
-
Not so much what I did do today as didn`t do ! I drove over the workshop this morning to generally fettle , tinker and polish the Vette...
-
Roscobbc replied to the thread Recurrent misfiring problem.Good points Jon - whilst the MSD system puts out more than enough spark for most applications - I've found that the MSD rotor arm can...
-
teamzr1 replied to the thread Recurrent misfiring problem.Did you check the distributor cap contact points for wires 3,5 and 7 ? Does the cap sit level and seated OK ? How about a weak ground to...
-
antijam replied to the thread Recurrent misfiring problem.As you say Rosco, probably not my problem but an interesting possibility. I'm going to pull the manifold; if a failed gasket is my...
