PDR Software Glitch

Rich Steel

CCCUK Member
On our way home from the Lakes, a truck pulled in front of me on the motorway and a sizeable rock (and other debris) flew off it and hit my windscreen. I wanted to check-out video from the PDR (which I have set to auto-record) when I got home, but when I tried to load it just got a blank screen. I removed the SD card to check its contents and found that, on our previous day's trip out to the Lakeland Museum, the PDR had carried-on recording all the time we were parked at the museum, and had continued for a further 23 minutes on the journey home until it abruptly stopped.

With the help of AI (scares me no end, but use it just the same!) I found this was likely a software glitch...

Modern GM vehicles use a communication network (CAN bus) to manage power states. When you shut off the car and open the door:
  1. The Body Control Module (BCM) broadcasts a "Go to Sleep" command across the network.
  2. The infotainment screen received it and shut off successfully (which is why your screens were blank).
  3. However, the dedicated PDR hardware module (which physically sits separately up by your rearview mirror) missed or failed to process that network command.
  4. The reason it suddenly ended 23 minutes into your drive is due to the C8's battery management system:
    When you started the car with a heavily drained battery, the vehicle's alternator immediately went into high-output charging mode. To protect vital engine systems and rapidly charge the 12V battery, the car's computer aggressively shuts down or drops voltage to non-essential accessories (called Load Shedding). About 23 minutes into the drive, the system likely cut accessory power or forced a background module restart to prioritize battery charging, which finally killed the stuck PDR loop.
This all makes sense... When I switched-on the car in Service Mode to setup the SatNav for our drive home the following morning, the DIC immediately reported "battery low: start engine".
The recommended actions were to check the SD card was error-free/ had no corrupt files. (It was fine, but I reformatted it anyway.) I disconnected the battery terminals and touched them together to drain the residual power stored in the vehicle's capacitors. "This forced every single computer module in your C8 to undergo a true 'cold boot' from a zero-power state."
This seems to have resolved the problem and the PDR is again working fine. It's the first time I've experienced this in three years of ownership, but I thought it may be worth reporting upon in case anyone else here has a similar experience. 😀
 
Last edited:
Top