Oldmacdonald
CCCUK Member
Getting a little annoyed by all the hud ccontrols constantly rattling away, has anyone found a simple way of tidily curing ti's problem?
Thanks
Thanks
Rattling HUD buttons.
- Thread starter Oldmacdonald
- Start date
teamzr1
Supporting vendor
That HUD switch control unit has just 2 screws on the backside that may have loosened up
Might be lucky and can get to them by looking up behind the dash ?
Or need a C5 service manual to see how to get that part of the panel out
May need to take the IP cluster out enough to get to the 2 bolts
Might be lucky and can get to them by looking up behind the dash ?
Or need a C5 service manual to see how to get that part of the panel out
May need to take the IP cluster out enough to get to the 2 bolts
C5Steve
CCCUK Member
Fairly certain you'll need to remove the entire dash to get the cluster out. You can apparently get it out by just loosening a few bits but it looks very tight. Have a look on YouTube for C5 cluster removal, there's a few videos on there of how to get it out.
I looked a long time ago when I wanted to change the bulbs, been putting it off ever since it looks like such a PITA! Oh and if you do pull the cluster out don't leave it face down.
I looked a long time ago when I wanted to change the bulbs, been putting it off ever since it looks like such a PITA! Oh and if you do pull the cluster out don't leave it face down.
Oldmacdonald
CCCUK Member
Thank for your advice, agreeing with C5Steve about accessibility, was hoping for an easier fix, set them where you want them and expanding foam came to mind!